[. . . ] This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. [. . . ] Tapping on a magnifying glass icon or on the summary text will open a pop-up screen with additional data; the right side of the screen provides interactive signal flow diagrams. The existing data will be read from the hardware to synchronize the Controller with the MY8-LAKE. Toggle between the [Host Out Ch] button and the [AES CH] button to select a module input source. If you want to change the output configuration, you will need to change the view to “Classic view” by following the steps below. Tap the [Routing Mode] All modules can be displayed by tapping and holding up/down to scroll. You can adjust the input level, and route or disconnect input signals to any module by using the ON/ OFF buttons and fader controls. Magnifying glass icon at the bottom left of the I/O Config screen, then select the “Classic view” from the pop-up menus. In the Classic view, by default the Mesa Module Outputs A – H are routed simultaneously to both the “Host” returns 1 – 8 and to “AES” channels 1 – 8 just as in the Simplified view. Tap the blue arrow at the bottomright of the screen to close the Input Mixer. NOTE • For host devices unrecognized by the MY8-AE96 (such as DIO8), you will need to change the emulation mode of the card to MY8-AT by tapping the [Operation Mode] magnifying glass icon at the bottom left of the screen and reboot the host device. Tap one of the blue boxes in the module’s input mixer block diagram. €¢ The digital clock and input configuration summary can be found at the top left of the screen. You can adjust the input level, and route or disconnect input signals to any module by using the ON/ OFF buttons and fader controls. Tap any of the magnifying glass icons on the far right of the screen. The Output Configuration screen will be displayed allowing you to route any MY8-LAKE Owner’s Manual 15 available audio source to any available output destination. levels Screen The Levels screen provides access to controls for gain , delay , LimiterMax , input mixer , mutes and polarity adjustments. This section describes various example scenarios to highlight key functionality. The orange numbered blocks show which module output is routed to which of the currently selected “Destination” outputs. The currently displayed audio “Source” defaults to show the number of “Module Outputs” channels listed on the left and the visible audio “Destination” defaults to display the “Host” returns. The currently displayed view can be changed by tapping the appropriate left or right arrows beneath the “Source” and “Destination” labels. NOTE Tap an orange numbered button to disconnect that source/destination routing only (turns blue); tap a blue numbered button to patch the source to the destination. The Disconnect All button can be used to disconnect all outputs for the displayed source/destination matrix. [. . . ] Check that all Input Router, module Input and module Output Mutes are properly unmuted. Has the signal been connected correctly in the input router and module input mixer?Has the signal been correctly routed to the outputs via the Output Configuration screen?Unusual Sound (noise, interruption, or distortion) Is the FAULT LED of the MY8-LAKE illuminated? [. . . ]